Where is Optus D1?

Launched in 2006, Optus D1 is located at 160°E. It has 24 Ku-band transponders servicing Australia and New Zealand – and is New Zealand’s hotbird because of its broadcasting load. Launched in 2006, Optus D1 is located at 160°E….Optus D1.

What frequency is Optus D1?

12.456 GHz
There will temporarily be a second signal on D1 on frequency 12.456 GHz, also “horizontal”, but this will disappear one week after the transfer. Q.

What is LNB on Freeview?

Live TV signals for FreeviewPlus® and Freeview Satellite® are transmitted from the Optus D1 satellite. We recommend a minimum dish size of 60cm with a single 11.300 GHz LO Frequency LNB. If you’re using a satellite dish to pick up TV signal, make sure you get an approved product that works with a satellite dish.

How high is Optus satellite?

156°E.
It sits at 156°E. In 2003, Optus successfully launched the world’s largest hybrid commercial and military communications satellite Optus C1, together with the Australian Defence Forces….Optus C1.

How do you set the satellite azimuth and elevation?

Stand behind the dish and rotate your compass horizontally until the needle is aligned with the north and south readings on the dial. Rotate the satellite dish to face the direction indicated by the degrees on the compass. Tighten the bolts on the mounting collar with a wrench when the dish is in the correct position.

How do I align my satellite dish UK?

The variation needed for the UK is about 5 degrees, this will mean for the United Kingdom you will need to align your dish to a compass bearing of about 23 degrees east of south. Now that you have the dish roughly aligned left to right with the compass bearing The second step is to align the dish vertically.

What should my satellite settings for Freeview?

If your telly gets Freesat or Sky subscription-based services, you want to align your satellite dish towards the Astra 2 Satellites or the Eurobird. For Astra 2 Satellites, the satellite alignment should be at 28.2E while for Eurobird, moving the dish to 28.5E should do the trick.

How do I tune my Freeview satellite?

Guide to Tuning

1. Press the Menu or Settings on your remote.
2. Select Programmes / Broadcast / Channel / Set-Up.
3. Select Tuning option, if you’re prompted to choose between Analogue/ATV and Digital/DTV, always pick Digital/DTV.
4. Start Auto Tuning or Auto Set-Up to start tuning, on some TVs you have to select Start to confirm.

What frequency should my Freeview TV be on?

Digital TV (Freeview) Frequencies – 470Mhz – 800Mhz (Future 700Mhz) With regards to TV aerial reception for digital TV services is 470-850Mhz.

How to turn dish to point Optus D1 New Zealand?

Insert Satellite Finder in cable between receiver and LNB, note connection direction on the rear of the meter. 7. Adjust control clockwise until tone sounds then reduce for no sound. Turn dish westwards on mount until tone increases as it picks up signal from satellite. The meter reading should go off the scale when you “hit” a satellite.

How tall is the Optus D1 in New Zealand?

All direct broadcast services for subscription and free-to-air television to New Zealand are carried on Optus D1 making it the New Zealand hotbird. 3.9 metres high x 17 metres wide with solar arrays deployed.

What is the LNB for Optus D1 satellite?

Press ‘OK’ on ‘Satellite Name’and scroll up and down to select Optus D1. (If Optus D1 is not available just select ‘Other’ ). 3] Move down to ‘LNB Frequency’. You need to set this to your LNB. Your LNB is likely to be either 11300 or 10750.