What radios work with Crossfire?

The Crossfire module is fully compatible with Taranis X9D+, Jumper T18, T16, and the RadioMaster TX16S. It also works with Taranis Q X7, and Horus X10S, but there are some minor issues due to the inability of operating at full baud rate, causing problems such as constant warning of “telemetry lost”.

Is Crossfire compatible with Taranis qx7?

At the back of your Taranis Q X7 and X9D, there is a little hatch that opens up to reveal slot for inserting a module. The TBS Crossfire Micro will snap into that – insert it all the way until the little tabs click. Screw on the antenna that came with the Crossfire, and power on your radio.

What frequency is TBS crossfire?

The CROSSFIRE Micro TX has a standard JR-form factor and works with any radio that supports PPM-stream and/or TBS CRSF-format output. Transmitter power is selectable between 25mW and 100mWi and TX status is shown using a RGB LED lite behind the push button. Frequency band 868 MHz and 915 MHz are supported.

What is TBS CROSSFIRE v3?

The TBS CROSSFIRE is a long range R/C link based on the newest RF technology, capable of self-healing two-way communications, ultra-low latency and range beyond comprehension.

What is Crossfire RC?

What is Crossfire radio control?

The TBS Crossfire is a UHF system designed for people that demand the very best radio system available for their quads and wings. This is a Simple drop in module used to turn your radio into a robust UHF system that can achieve maximum range with exceeding reliability.

What frequency is crossfire?

TBS CROSSFIRE supports two different frequency bands which are 868mHz and 915mHz.. It operates on 868 MHz in ITU-1 (Europe), and on 915MHz (rest of the world).

What does TBS crossfire do?

What is Crossfire LQ?

Besides RSSI, Crossfire receivers can also output LQ, which stands for “Link Quality“. The Crossfire LQ is scaled from 0% to 300%, not 0% to 100% like RSSI. A Crossfire LQ between 300 and 200 means it’s in 150 Hz Mode, between 200 and 100 it’s 50 Hz Mode and then it switches to 4 Hz Mode below 100 LQ.

Is the TBS Crossfire on the back of the Taranis?

The TBS Crossfire is a popular RC system for long range flying. It’s an external RF module that can be installed directly on the back of the Taranis and Nirvana, so you can still use the powerful OpenTX interface. The Crossfire operates at the 900MHz band, the low frequency means excellent signal penetration…

What kind of radio does a TBS crossfire use?

What’s TBS Crossfire? The TBS Crossfire is a popular radio control system for long range FPV drones. It’s an external RF module that can be installed directly on the back of a radio transmitter (i.e. JR module bay). Rather than the typical 2.4GHz that is used in most RC systems, the Crossfire operates at the 900MHz band.

Where to install the crossfire TX module in a Taranis?

Installing Crossfire TX module in the Taranis. You can install the Crossfire TX module directly in the external module bay in your Taranis. Insert the module into the module bay very carefully, make sure all the pins go into the sockets of the Crossfire module properly.

How to update the firmware of TBS crossfire?

Updating TBS Crossfire Firmware. Update your Crossfire TX module to the latest firmware. Launch TBS Agent, and connect your Crossfire TX module to your computer using the Micro USB port. If there is a newer version detected, click the “Update” button to update the firmware.