How do I reset my GE front load washer?

Plug the washing machine back in and then within 30 seconds, quickly open and close the lid six times. You’ll need to do this within a 12-second period. Raise the lid at least 2 inches and make sure it closes each time. This should complete the motor reset.

How do you put a GE washer in test mode?

Test Mode is initiated by pressing a sequence of buttons on the washer’s control panel.

1. Press the “Power” button on your GE washer.
2. Unplug the power cord for at least 30 seconds.
3. Plug the power cord back in to the GE washer.
4. Press “Delay Start” to advance to “t02”.

How do I troubleshoot my GE front load washer?

How to Troubleshoot a GE Front Load Washer That Won’t Spin or…

1. Remove any kinks in the drain hose.
2. Inspect the household drain.
3. Check the drain and make sure there is an air gap between the hose and drain.
4. Clean the pump filter.
5. Rearrange the clothing in the load.
6. Allow the washer to cool down for two hours.

How do I test my GE washer?

To enter the LED and buttons test mode on a GE front load washer, rotate the control knob until t04 is displayed in the control panel then press start/pause to enter the test mode. This test mode will test to see if each button works and each LED will light. Each light should blink once in a loop.

How do you unlock the controls on a GE washing machine?

To lock or unlock the washer controls:

1. Press and hold the LOCK button for 3 seconds.
2. A sound is made to indicate the lock/unlock status. The control lock icon on the display will light up when the feature is on.

How to enter water heater test mode on GE front load washer?

To enter the water heater test mode on a GE front load washer, rotate the control knob until t07 is displayed in the control panel then press start/pause to enter the test mode. Once this test is entered, the washer will start to fill with water until the main water level is reached.

How to do the spin test on a GE front load washer?

To enter the spin test on a GE front load washer, rotate the control knob until t11 is displayed then press start/pause to enter the test mode. Once the test mode is entered, the tub will start to spin and the rpm will be displayed in the control panel.

Where is the overflow line on a GE front load washer?

Overflow is approximately 6 inches above the door opening. Soon after the overflow water level is reached, the water pump will energize and pump the water out. Once the tub is empty again, “E” will be displayed again. Pressing power anytime during the test mode will exit the test mode.