How do you open a First Alert safe without the combination?

Opening a Safe Without the Combination

1. First you must find the safe’s emergency key.
2. Remove the panel that covers your safe’s dial.
3. Once you have removed the dial panel, take a look beneath the dial itself.
4. Insert the emergency key into the emergency keyhole and turn it until the safe opens.

How do I unlock my First Alert safe?

Turn the dial LEFT, passing the third combination number ONE (1) time and stop at the number on the second time around. Turn the dial RIGHT and STOP on the fourth combination number. Turn the handle upward to the RIGHT to open the safe. note: this waterproof safe may require additional force upon initial entry.

How much does a first alert safe cost?

First Alert 2087F Safe with Combination Lock, 0.94 Cubic Foot, Grey

How do you open a fire safe?

Lay the safe flat on a surface so you can easily access the lock. Insert the tip of the screwdriver where you would normally put the key. Turn the screwdriver counter-clockwise until the lock releases. Straighten out a paper clip, if the screwdriver didn’t release the lock.

How do you open a combination safe with a key?

Dialing a Safe

1. Start by turning the dial to the RIGHT a minimum of 4 turns (this clears the dial of any previous attempts) and STOP on the FIRST number of your 4 digit combination.
2. Turn the dial to the LEFT passing the SECOND number TWICE, stopping on the SECOND number of your combination on THIRD turn.

How do you open a First Alert safe with a dead battery?

Using your personal Passcode or Emergency Override Key, open the safe door and locate the battery compartment on the back of the door. Press firmly in on the right side of the battery compartment cover and slide to the left to open.

Where is the model number on a First Alert safe?

Locating Model and Serial Numbers Most First Alert® safes include a small metallic silver or gray tag affixed to one of the surfaces. This tag is usually located on the front or right side of the safe. This tag contains the Serial Number, and on selected models a similar tag is attached containing the Model Number.

Where are First Alert safes manufactured?

China
The manufacturers are in China. Products sold with the brand include carbon monoxide detectors, smoke alarms, fire extinguishers, and other safety products like flashlights and fire escape ladders.

How do you change the battery in a First Alert safe?

Using your personal Passcode or Emergency Override Key, open the safe door and locate the battery compartment on the back of the door. Press firmly in on the right side of the battery compartment cover and slide to the left to open. Remove the 4 old batteries and replace with 4 new Alkaline “AA” batteries.