Helpful tips

Does a Chevy Cobalt have a timing belt or timing chain?

Does a Chevy Cobalt have a timing belt or timing chain?

The chevy cobalt has a timing chain instead of a belt.

How much is a timing chain for a Chevy Cobalt?

Chevrolet Cobalt Timing Chain and Gear Set Replacement Cost Estimate. Labor costs are estimated between $405 and $511 while parts are priced at $291.

Can a broken timing chain ruin the engine?

A broken timing chain will cause an engine to not start or fail while driving. If the belt is already broken, the engine won’t have enough compression to start. If it breaks or jumps while driving, the pistons will be damaged from contact with the valves. The valves themselves will bend and potentially ruin the engine.

How long do Chevy Cobalts usually last?

With proper care and maintenance a 2008 Chevy Cobalt should be able to last at least 200,000 miles. The Cobalt has a very simple four cylinder engine in it, and that is a platform that is very easy and affordable to repair if anything goes wrong.

Does a 2005 Chevy Cobalt have a timing belt?

It might be a good idea to stay away from the 2005 and 2006 Cobalt, as they had more problems. On the plus side, the Cobalt’s engine and transmission were mostly trouble-free. All four Cobalt engines have a maintenance-free timing chain; there is no timing belt to worry about.

How much does it cost to have a timing chain replaced?

For most cars, a timing chain replacement costs between $413 and $1040, or you can order the parts themselves for $88 and $245. It is a tricky repair though, so unless you’re particularly skilled it’s usually best left to a mechanic.

Is it hard to replace timing chain?

Changing a timing chain is not outright difficult but is considered a complex job due to the large number of steps involved. The timing chain and water pump are both labor-intensive jobs in the same area of the engine, so knocking out both now can prevent having to do many of the same steps again later.

How do you change the timing chain on a Chevy Cobalt?

•Use a suitable tool with a rubber tip on the end. Feed the tool down through the camshaft drive chain to rest on the timing chain. Then give a sharp jolt diagonally downwards to release the tensioner. •Use a 24 mm wrench to hold the camshaft.

Which is Chevy Cobalt models have a belt / chain?

Which models have a belt/chain? All Chevy Cobalt car engines such as the LNF, LSJ, L61 etc have timing chains and not belts. The 2.2 L L61 ecotec outputs 144 hp to 148 hp and the 2.2 LAP ecotec that was introduced in 2009 outputs around 155hp. The 2.4 L has an output of 173 hp.

What should I do with my timing chain removed?

Caution: With the timing chain removed, avoid turning the camshaft or crankshaft. If movement is required, exercise extreme caution to avoid valve damage caused by piston contact. 1. Disconnect and isolate battery ground cable. 2. Raise and support vehicle with jack stands. 3. Remove front fender liner. 4. Turn drive belt tensioner clockwise. 5.

What kind of transmission does a Chevy Cobalt have?

Cobalt cars came with a 5 speed F35, Getrag F23 manual and a 4 speed 4T45 automatic transmission.